How does Tarkov sensitivity compare to CS2 or Valorant?

Tarkov's sensitivity system doesn't have a published yaw value, making exact mathematical conversion difficult. Our converter uses empirically measured conversion factors based on community testing. As a rough reference: CS2 sensitivity 2.0 at 800 DPI (approximately 35 cm/360) maps to approximately Tarkov sensitivity 0.14-0.16 depending on your screen resolution and version. Because Tarkov updates its engine periodically, re-verify your sensitivity with the tape method after major patches, as sensitivity scaling occasionally shifts between versions.

Should I use different sensitivity for different weapon types in Tarkov?

Tarkov allows per-scope-category sensitivity, not per-weapon sensitivity. However, you can psychologically adapt different technique for different weapon roles: pistols and shotguns at very close range may be handled more instinctively (faster wrist movements, hipfire more often), while bolt-action sniper rifles demand deliberate, controlled breathing and trigger timing. The sensitivity value should remain constant — what changes is your technique, breathing (holding breath with the appropriate key), and shot timing based on the recoil pattern of each weapon class.

Why does Tarkov feel so different from other FPS games even at the same cm/360?

Tarkov's distinctiveness comes from: (1) Severe weapon inertia that makes your character feel "heavy" — your aim is fighting momentum, not just moving freely. (2) Fatigue system — running reduces stamina, and low stamina increases sway and reduces ADS stability. (3) Health system — limb hits cause accuracy penalties, head-jaw hits cause strong screen blur. (4) Armor and helmet weight distribution affects movement speed. (5) Psychological pressure — the permanent death of your gear makes aim feel different in a high-stakes moment compared to a respawn game. The sensitivity is correct; the game is deliberately slower and more deliberate than any other FPS.

Does Tarkov have raw mouse input?

Tarkov does not have an explicit "raw input" checkbox like CS2 or CoD. However, it does minimize Windows pointer interference through its own input handling. The most important step for Tarkov is to disable Windows Enhance Pointer Precision in Mouse Properties → Pointer Options, and to disable any DPI shifting or acceleration in your mouse software. Running your mouse at a fixed DPI with no acceleration applied at the hardware level ensures Tarkov receives consistent input counts regardless of mouse speed.

Gaming Tools2026-05-10

Escape from Tarkov Sensitivity Converter — EFT Settings Guide

Escape from Tarkov is unlike any other FPS on this list. Its survival extraction format means you may only fire your weapon a handful of times per raid, but every shot carries enormous stakes — your gear and your life. Tarkov's sensitivity system uses a decimal multiplier (0.001 to 1.000) that feels intentionally imprecise until you understand how the game's unique aiming mechanics work: free look, prone inertia, ADS with and without breath hold, and the distinction between hipfire and every individual optic tier each require separate tuning. Tarkov also features one of the slowest movement speeds and most severe ADS penalties of any modern FPS. Hipfire is rarely viable; almost all engagements happen through sights or scopes. This means your ADS sensitivity values matter far more in Tarkov than in any run-and-gun shooter. Our converter translates your preferred cm/360 to Tarkov's decimal system and provides guidance on how to approach each context.

settings_input_component

Escape from Tarkov Sensitivity Converter

Free · No registration

Try this tool for free →open_in_new

Step-by-Step Guide

Understand Tarkov's sensitivity contexts

Before converting, know that Tarkov has at least five independent sensitivity contexts: Mouse Sensitivity (free-look and menu), General mouse sensitivity (hipfire), Aiming (optics ADS), different values per optic type, and Scope sensitivity. The general sensitivity slider handles hipfire and walking/moving situations. The "Aiming" slider applies when you ADS without magnification. Individual scope categories handle magnified optics. You'll set the hipfire value from the converter first, then configure each scope category separately.

Convert your hipfire sensitivity

Enter your source game DPI and sensitivity into the converter. Select Escape from Tarkov as the target. The converter outputs a decimal value for Tarkov's sensitivity slider. In Tarkov, go to Settings → Controls → Mouse Sensitivity. Set the General Sensitivity to the converter's output. Verify with the tape method in the offline practice mode — Tarkov's hideout scav raid training area is ideal for this. Your 360° rotation distance should match your target cm/360.

Set non-magnified ADS sensitivity

Tarkov's non-magnified ADS (iron sights, red dot sights, collimators) uses the "Aiming Sensitivity" slider. Most experienced Tarkov players set this 10-20% lower than hipfire. In Tarkov's high-stakes engagements, you rarely hipfire — steady, precise ADS movement matters more than fast flicking. Set Aiming Sensitivity to 80-85% of your hipfire value and validate in offline raids at 15-30 meter ranges (typical indoor engagement distances in Factory, Customs buildings, Reserve).

Configure magnified scope sensitivities individually

Tarkov has separate sliders for different optic categories (1x magnification, 1-4x zoom, 4x+, thermal, etc.). For each scope category, start at 50-70% of your hipfire value and test at the ranges appropriate for that scope class. Low-power variable scopes (1-4x) in use at 50-100m benefit from values around 60-70% of hipfire. High-power fixed scopes (6x, 7x, 8x) used at 150-400m sniper ranges should be 30-50% of hipfire. The goal is that the same physical mouse movement feels proportionally similar regardless of magnification.

Practice in offline raids and Factory

Tarkov does not have a traditional training range or deathmatch mode, but offline raids are free of consequence. Run offline Factory raids (the smallest, most combat-dense map) to practice target acquisition, ADS transitions, and close-range engagement. Factory's tight corridors force a wide variety of engagement types: 3-5m hallway shots, 15m room clears, and 25m L-shaped corridors. Use these to validate both hipfire and ADS sensitivity before taking your settings into live raids where death costs real gear.

Account for Tarkov's inertia and recoil

Tarkov has severe weapon inertia — your gun physically sways when you stop moving or change direction, requiring you to account for this visual movement in your aim. Recoil is also the most punishing of any FPS, with full-auto rifles climbing dramatically after the first two rounds. Your aim in Tarkov is about burst control and weapon management as much as raw mouse sensitivity. After converting, focus more on burst timing and recoil pulls than on raw flicking speed — Tarkov rewards patience and precision over twitch aim.

Tips & Best Practices

check_circle

Tarkov's "Free Look" sensitivity (holding Alt while moving) can be set independently — most players set it 1.5-2x higher than combat sensitivity for faster peripheral checking.

check_circle

Disable mouse smoothing and mouse filtering in your mouse software — Tarkov's engine is sensitive to input inconsistencies.

check_circle

Windows Pointer Precision (mouse acceleration) must be off — Tarkov is one of the most punishing games for inconsistent mouse movement due to its one-shot-kill potential.

check_circle

Headgear with NVGs increases visual noise and perceived jitter — you may want to temporarily reduce sensitivity by 5-10% when running NVGs in dark areas until you're accustomed to the overlay.

check_circle

Tarkov has a "prone sensitivity reduction" that changes your sensitivity when lying prone — account for this when configuring long-range sniper scoped settings.

check_circle

The "Sight Zeroing" key (Page Up/Page Down) changes bullet drop compensation at range — learn this system so you don't confuse missed long shots with sensitivity issues.

check_circle

High-recoil weapons in Tarkov (SVD, RSASS, M1A) require deliberate single-shot discipline — if you're struggling to land follow-up shots, reduce sensitivity by 10-15% to improve your recoil pull control.

Frequently Asked Questions

The Tarkov community generally recommends lower sensitivity than most other FPS games: 800 DPI with sensitivity between 0.12-0.18 (producing approximately 28-42 cm/360) is a common range. Streamers and content creators vary widely, but most experienced players (1000+ hours) who have optimized settings land in the 30-50 cm/360 range for hipfire, reflecting Tarkov's deliberate, tactical pace. There is no "pro scene" sensitivity data since Tarkov doesn't have organized esports yet, but the community consensus on forums like r/EscapefromTarkov skews toward lower-than-average sensitivity compared to other FPS games.

Escape from Tarkov's high-stakes extraction format makes sensitivity calibration more critical than in almost any other game — every missed shot potentially costs thousands of rubles of gear. Convert your hipfire sensitivity using our tool, then methodically work through each scope category starting with the optic types you use most frequently. Spend time in offline raids to verify each context before risking your kit in live raids. Once your settings are right, lock them and don't touch them — Tarkov rewards players who invest time in a single configuration rather than constantly chasing marginal improvements.

Try this tool for free →open_in_new